Enterasys 2000 Especificações descarregar pdf (Página 75)

Enterasys Xpedition 2000 Getting Started Guide 61

Activating Configuration Changes and Saving the Configuration File

Viewing the Current Configuration

If you want to view the current configuration:

1. Ensure that you are in Enable mode by entering the enable command in the CLI.

2. Enter the following command to display the status of each command line:

The CLI displays the active configuration file with the following possible annotations:

– Commands without errors are displayed without any annotation.

– Commands with errors are annotated with an “E”.

– If a particular command has been applied such that it can be expanded on

additional interfaces/modules, then it is annotated with a “P”. For example, if you

enabled stp on all ports in the current system, however, the XP contains only 1

module, then that particular command could be expanded at a later date when

more modules have been added to the XP.

A command like stp enable et.*.* would be displayed as follows:

indicating that it is only partially applied. If you add more modules to the XP at a

later date and then update the configuration file to encompass all of the available

modules in the XP, then the “P:” portion of the above command line would

disappear when displaying this configuration file.

If a potentially partial command, which was originally configured to encompass

all of the available modules on the XP, becomes only partially activated (after a

hotswap or some such chassis reconfiguration), then the status of that command

line will automatically change to indicate a partial completion status, complete

with “P:”.

Note: Commands with no annotation or annotated with a “P:” are not in error.

system show active-config

P: stp enable et.*.*

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 81 82 83

Sem comentários

Enterasys 2000 Especificações Página 75