Enterasys Enterasys SecureStack B2 B2G124-24 Guia de Instalação descarregar pdf (Página 44)

Connecting AC and RPS-SYS Power

3-16 Hardware Installation

Figure 3-8 Switch Rear View

3. ObservethatthepowerCPULED(notshown),locatedonthefrontpanel.Duringthe

initialization,theCPULEDwillstartbyilluminatingsolidamber,thenstartblinking

green,thenblinkingamber,thenblinkinggreenagainuntiltheendofthe

initialization,andthenturnssolidgreen.

Iftheswitch

isastandaloneswitch,itwilltakeapproximately30 secondsforthe

switchtostartup.IftheswitchisastackManager,itcantakeupto3minutesormore

tostartup,dependingonthenumberofMemberswitchesinthestack.

1 AC power cord 2 AC power connector 3 Connector for external redundant power supply

Note: If the CPU LED illuminates solid red, there was a critical failure. For more

information about the LED indications and troubleshooting, refer to Chapter 4. If you need

additional help, contact Enterasys Networks. Refer to “Getting Help” on page 1-8 for

details

C AD

SERIAL NO

AC LINE

100-240 VAC

50-60 Hz

0.8 A MAX

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 77 78

Sem comentários

Enterasys Enterasys SecureStack B2 B2G124-24 Guia de Instalação Página 44