Enterasys Matrix E7 Guia de Configuração descarregar pdf (Página 28)

Setting Up the Matrix E7 Chassis

3-4

3.2.2.1 Installing the Rubber Feet

To install the rubber feet, proceed as follows:

1. Remove the four rubber foot/screw assemblies from their plastic bag in the shipping box.

2. Locate the four tapped holes in the bottom four corners of the chassis shown in Figure 3-1.

Figure 3-1 Chassis Bottom, Rubber Feet Placement

3. Screw in and hand tighten each of the four rubber foot/screw assemblies into the four tapped

holes. Then tighten with a Phillips screwdriver.

4. After installing the rubber feet, proceed to install the Cable Management Bar.

3280-00-14

Bottom of Chassis

Tapped hole

for rubber foot

(Four places)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 45 46

Sem comentários

Enterasys Matrix E7 Guia de Configuração Página 28