Enterasys C2RPS-SYS Guia de Instalação descarregar pdf (Página 58)

Connecting to the Network

3-30 Hardware Installation

Figure 3-21 Cable Connection to LC Fiber-Optic Connectors

3. Plugtheotherendofthecableintotheappropriateportontheotherdevice.Some

cablesmaybeterminatedattheotherendwithtwoseparateconnectors,oneforeach

fiber‐opticstrand.Inthiscase,ensurethatthetransmitfiber‐opticstrandisconnected

tothereceiveport

andthereceivefiber‐opticstrandtothetransmitport.

4. VerifythatalinkexistsbycheckingthattheportLink/ActivityLEDison(blinking

greenorsolidgreen).IftheLink/ActivityLEDisoff,performthefollowingstepsuntil

itison:

a. Verifythatthedeviceattheotherendof

thesegmentisONandconnectedtothe

segment.

b. Ifthereareseparatefiber‐opticconnectionsontheotherdevice,checkthe

crossoverofthecables.Swapthe cableconnectionsifnecessary.

c. Checkthatthefiber‐opticconnectionmeetsthedBlossandcablespecifications

outlinedintheCablingGuidefor

multimodemodecabling.Toobtainthis

document,referto“RelatedDocuments”onpage xvi.

d. Ifalinkhasnotbeenestablished,refertoChapter 4forLEDtroubleshooting

details.Ifaproblempersists,refertoreferto“GettingHelp”onpage xviiifor

detailsoncontactingEnterasys Networksforsupport.

5. Repeatsteps1

through4,above,untilallconnectionshavebeenmade.

1 Mini-GBIC MT-RJ port connector 3 Release tab

2 LC cable connector 4 Link/Activity LED

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 77 78

Sem comentários

Enterasys C2RPS-SYS Guia de Instalação Página 58