Enterasys C2RPS-SYS Guia de Instalação descarregar pdf (Página 38)

Rack Mounting the Switch

3-10 Hardware Installation

Attaching Brackets and Installing in Rack

Proceedasfollowstoinstalltheswitchintoa19‐inchrack:

1. Attachtherackmountbracketstothe switch,asshowninFigure 3‐7,usingtheeight

M3x6mmflatheadscrewsshippedwiththeswitch.

Figure 3-7 Attaching the Rackmount Brackets

2. Withthemountingbracketsattached,positiontheswitchbetweentheverticalframe

membersofthe

19‐inchrackasshowninFigure 3‐8.Thenfastentheswitchsecurely

totheframeusingfourmountingscrews(usersupplied).

Figure 3-8 Fastening the Switch to the Rack

3. Ifyouare installingthisswitchinastackedconfiguration,repeatthisprocedurefor

eachswitchuntilallswitcheshavebeeninstalledinthestack,thenproceedto

“ConnectingHigh‐SpeedStackingCables”onpage 3‐11.Otherwise,proceedto

“ConnectingACandRPS‐SYSPower”onpage 3‐15.

1 Rackmount brackets 2 M3x6 mm flathead screws

1 Rails of 19-inch rack 2 Mounting screws (supplied by user)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 77 78

Sem comentários

Enterasys C2RPS-SYS Guia de Instalação Página 38