Enterasys Enterasys Matrix DFE-Gold Series Guia do Utilizador descarregar pdf (Página 97)

Managing Router Configuration Files

Matrix DFE Series and N-SA User’s Guide 7-11

Saving or Erasing the Running Configuration

FromprivilegedEXECmode,usethiscommandtosavetherouterrunningconfigurationto

NVRAM,toeraseit,ortodisplayittooutputdevices.

write [erase | file [filename config-file] | terminal]

Iffilenameconfig‐fileisnotspecified,theconfigurationwillbesavedtostartup.cfg.

Ifnooptionsarespecified,theconfigurationwillbedisplayedtotheterminal.

Removing the Routing Configuration from the Device

Fromglobalconfigurationmode,usethiscommandtodisableIProutingonthedeviceand

removetheroutingconfiguration.Bydefault,IProutingisenabledwheninterfacesareconfigured

foritasdescribedinCreatingandEnablingIPRoutingInterfacesonpage 7‐7.

no ip routing

Performing a Basic Router Configuration

Using Router-Only Config Files

AlthoughtheMatrixDFESeries/N‐SA’ssingleconfiguration interfaceprovidesonesetof

commandstoperformbothswitchandrouterconfiguration,itisstillpossibletouserouter‐only

commandstoconfiguretherouter.Todoso,youneedtoaddrouterconfigwrapperstoyour

existingrouterconfig

files,as showninthefollowingexample.

Example

Thisexampleshowshowtoaddrouterconfigwrapperstoafile.Inthiscase,“beginrouter1”is

placedatthebeginning,and“endrouter1”wasplacedattheendoftheconfigfile:

Note: The write file command must be executed in order to save the router configuration to

NVRAM. If this command is not executed, router configuration changes will not be saved upon

reboot.

begin router 1

enable

conf t

write file

exit

disable

exit

end router 1

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 137 138

Sem comentários

Enterasys Enterasys Matrix DFE-Gold Series Guia do Utilizador Página 97