Enterasys C2RPS-SYS Guia de Instalação descarregar pdf (Página 46)

Connecting to Console Port for Local Management

3-18 Hardware Installation

Stack Initialization Overview

Whenyouinstallandconnectallthestackingcablestotheswitchesinthestackbefore 

applyingpowertotheswitches,thefollowingoccurs:

•Theswitchthatwillmanage(Manager)thestackisautomatically establishedwithall

otherswitchesestablishedasMemberswitchesinthestack.Whentheswitches

completetheirinitializations,oneoftheswitchesinthestackwillilluminateits

ManagerLED,indicatingthatitisthestackManager.TheManagerLEDon

each

Memberswitchwillbeoff.

•ThehierarchyoftheswitchesthatwillfunctionasbackupManagerisalsodetermined

incasethecurrentManagermalfunct ions ,ispowereddown,orisdisconnectedfrom

thestack.

•TheConsoleportoneachMemberswitchwillprovideonlytheunitnumber.Onlythe

Console

portontheManagerswitchisactiveandprovideaCLIforout‐ofband 

configurationtosettheIPaddress,password,andothersettings.

OnceyouknowwhichswitchistheManager,proceedto“ConnectingtoConsolePortfor

LocalManagement”onpage3‐18.

Connecting to Console Port for Local Management

ThissectiondescribeshowtoconnectanRS232DTEinterfacecablefromaPC,aVTseries

terminal,oramodemtoanA2H254‐16forout‐of‐bandsessionsusingCLIcommands.

What Is Needed

Thefollowingisalistofuser‐suppliedDTEinterfacecablesthatmaybeneededtoconnect

theDB9maleConsoleportconnectorontheswitch.ThecablesareterminatedbyaDB9

femaleconnectoratoneend,andbyoneofthreetypeconnectorsattheotherend,

dependingon

thetypeconnectionneededfortheremotedevice.Thecablesthatmaybe

neededareasfollows:

•DB9female‐to‐DB9female

•DB9female‐to‐DB25female

•DB9female‐to‐DB25male

UsingaDTEmodemDB9female‐to‐DB9femalecable,youcanconnectproducts

equippedwithaDB9DTEmaleconsoleporttoan IBMorcompatiblePCrunningaVT

seriesemulationsoftwarepackage.

Note: When switches are connected in a stack configuration and all stacking cables are

connected before powering up the switches, one switch in the stack will be automatically

designated as the Manager of the stack and its Console port will remain active. All other

switches will become Member switches and their Console ports will be deactivated.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 79 80

Sem comentários

Enterasys C2RPS-SYS Guia de Instalação Página 46