Enterasys APS-3000 Manual do Utilizador descarregar pdf (Página 3)

Release Notes

2.9 UI Enhancements

• AP->All page has been renamed to AP->List page

• Lucent has been renamed to Lucent/Orinoco on the Device Setup->Communication page

• AMP now includes username and password for Nomadix devices for the apparent IP link on the

AP->Monitor and the AP->List pages.

• Modify These Devices now supports moving APs between folders.

• New and Alert pages now display the row count.

• AMP users can disable vlan tagging on wireless vlans for roamabout 3000 APs.

• Max bandwidth for device bandwidth trigger has been increased to 200 Mbs

• All the edit icons on the AP list and Group list pages have been changed

• Default sort order on the RAPIDS->Rogue List page is now by the score column and ascending by

the age of the rogue.

Issues Addressed

3.1 AMP displays AP bandwidth on Nomadix HSG

AMP displays Ethernet bandwidth as AP bandwidth on the Nomadix HSGs. Please note that the group

bandwidth could have bandwidth doubly counted if the Nomadix HSG and the APs behind it are in the

same group.

3.2 Repairing config on the Group->Monitor page no longer has errors

Previously clicking on the “Repair” button resulted in errors. Now “repairing” the config from the

Group->Monitor page pushes config on the APs.

3.3 Inventory Reports include ssid from HP420

AMP now displays ssid in the inventory reports for HP420 and other APs.

3.4 AMP now uses the correct SNMP OID for HP420 APs

Now, the AMP uses the correct SNMP OID to read and display the radio mac address on the HP 420

APs.

3.5 Airespace Closed Network is backwards (Case 9763)

Closed Network on Group->Security page works correctly on the Airespace devices.

3.6 AMP clears Error Message on APs monitor page

Previously the AMP did not clear the “Error” configuration status messages until the configuration was

pushed on the AMP. Now these errors are cleared when the AMP is able to successfully push or fetch

configuration from the AP.

3.7 AMP supports Cisco 1200 with 802.11a radio

AMP supports and correctly displays information on the AP->Monitor page for Cisco 1200 APs which

have only a 802.11a radio.

3.8 AMP upgrades work for Red Hat AS 3.0

AMP upgrade works on the Red Hat AS 3.0.

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Enterasys APS-3000 Manual do Utilizador Página 3